No Spanning-Tree Mst - Siemens SIMATIC NET Configuration Manual

6.3.4.9

no spanning-tree mst

Description
With this command, you reset the various properties of the Multiple Spanning Tree function
to the default value.
The default values are as follows:
Parameter
cost
port-priority
disable
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
no spanning-tree mst<instance-id(1-64)>{cost|port-priority|disable}
The parameters have the following meaning:
Parameter
instance-id
cost
port-priority
disable
Note
Configure multiple properties
With each call of the command, you can configure precisely one property.
If you want to configure several properties, call the command several times.
Result
The selected setting is reset to the default value.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
Default value
200000 for physical interfaces
•
199999 for port channels
•
128
The Multiple Spanning Tree function is enabled on the interface
Description
Number of the addressed instance
Keyword for the costs of the port for
calculating the lowest-cost path.
Keyword for the priority of the interface
Enables the interface for multiple
spanning tree.
Network structures
6.3 Spanning Tree
Range of values / note
1 ... 64
-
-
-
273