This section describes commands for configuring and managing wireless LANs (WLANs).
Some commands are available only in the "access point" or in the "client" mode. In these
cases, the titles have the term access point or client added to them.
Example: wlan mode
● wlan mode (access point): The function can only be used with access points.
● wlan mode (client): The function can only be used with clients.
The "show" commands
This section describes commands with which you display various settings.
With the command
To do this, you replace
do show cli-console-timeout
show wlan advanced
This command shows information about the send characteristics of the SCALANCE W700
device, for example the beacon rate, fragmentation.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
Call up the command with the following parameters:
show wlan advanced <wlan 0/X>
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
you can execute the "show" commands in every
with the "show" command that you want to execute.