show wlan wds (access point)
This command shows the configuration of the WDS interface.
This command is available only in access point mode.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
Call up the command with the following parameters:
show wlan wds <wdsX 0/Y>
The parameter has the following meaning:
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
The following WDS settings are displayed:
● Admin status
● Connection over
● Partner ID type
● Partner MAC
● Partner WDS ID
Range of values / note
Enter a valid interface.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05