Wlan Rts-Cts Threshold; Commands In The Vap Interface Configuration Mode - Siemens SIMATIC NET Configuration Manual

Network structures
6.1 WLAN
6.1.5.56

wlan rts-cts threshold

Description
With this command, you specify the packet size starting at which RTS/CTS (Request To
Send/Clear To Send) will be used.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call up the command with the following parameters:
wlan rts-cts threshold < bytes(1-2346)>
The parameter has the following meaning:
Parameters
bytes
Result
The packet size is specified.
Further notes
You display the setting with the
6.1.6

Commands in the VAP Interface Configuration mode

This section describes commands that you can call up in the VAP Interface Configuration
mode. Depending on the Interface selected, various command sets are available.
In the Global Configuration mode, enter the
mode.
● If you exit the VAP Interface Configuration mode with the
the Global Configuration mode.
● If you exit the VAP Interface Configuration mode with the
Privileged EXEC mode.
206
Description
Size specified in bytes
show wlan advanced <wlan 0/X>
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Range of values / note
1...2346
Default: 2346
command.
command to change to this
interface vapX 0/Y
command, you return to
exit
command, you return to the
end
Configuration Manual, 10/2015, C79000-G8976-C351-05