The "Show" Commands; Show Authorized-Managers; Commands In The Global Configuration Mode - Siemens SIMATIC NET Configuration Manual

10.3.1

The "show" commands

This section describes commands with which you display various settings.
With the command
configuration mode.
To do this, you replace
Example
do show cli-console-timeout
10.3.1.1

show authorized-managers

Description
This command shows the information about the configuration of the authorized managers.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show authorized-managers[ip-source<ip-address>]
The parameters have the following meaning:
Parameter
ip-source
ip-address
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
Result
The information about the configuration of the authorized managers is displayed.
10.3.2

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
do [command]
[command]
or
cli#
Description
Keyword for the network or host ad-
dress
Value for an IP address
10.3 Management Access Control List
you can execute the "show" commands in every
with the "show" command that you want to execute.
configure terminal
or
end exit
Security and authentication
Range of values / note
-
specify a valid IP address
command to change to this mode.
command and are then in the
429