Send Test Mail - Siemens SIMATIC NET Configuration Manual

Diagnostics
11.1 Diagnostics
Syntax
Call up the command with the following parameters:
no link {up|down}
The parameters have the following meaning:
Parameters
up
down
Result
The settings for monitoring the physical network connections have been configured.
Further notes
You can display the current setting with the
You enable the function with the
11.1.6.8

send test mail

Description
With this command, you send an e-mail according to the currently configured SMTP settings.
Requirement
You are in the EVENTS configuration mode.
The command prompt is as follows:
cli(config-events)#
Syntax
Call the command without parameters:
send test mail
Result
An e-mail according to the currently configured SMTP settings is sent.
Further notes
You can display the current SMTP settings with the
450
Description
The message when establishing a connection is
disabled
The message when a connection is down is disa-
bled
command.
link
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Range of values / note
-
-
show events faults config
show events smtp-server
Configuration Manual, 10/2015, C79000-G8976-C351-05
command.
command.