Wlan Alternative Channel (Access Point) - Siemens SIMATIC NET Configuration Manual

6.1.5.4

wlan alternative channel (access point)

Description
If you have activated the DFS function, you specify the alternative channel with this
command. If the access point on the current channel discovers a disruption, it switches to
the alternative channel.
Note
This command is available only in access point mode.
Requirement
● The DFS function is enabled.
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call up the command with the following parameters:
wlan alternative channel { show-channels | <number (0=auto)> }
The parameters have the following meaning:
Parameters
show-channels
number
Result
The alternative channel is set.
Further notes
You display the setting with the
You enable the DFS function with the
See also
wlan dfs (Page 186)
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
Description
Lists all available channels.
Number of the alternative channel
If you want the access point to
search for a free channel itself, use
"0".
show wlan basic <wlan 0/X>
wlan dfs
Range of values / note
--
Default value: 0 (AUTO)
command.
command.
Network structures
6.1 WLAN
159