Configuration Mode General Commands - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Section 2.6.9.5

Configuration Mode General Commands

Configuration mode provides a set of general commands that allow users to work with configuration data.
Parameter
abort
clear
commit no-confirm
commit abort
commit and-quit
commit check
commit confirmed timeout
commit comment text
commit label text
commit persist-id text
commit save-running file
Configuration Mode General Commands
Description
Exits the configuration session without saving changes.
NOTE
In an edit exclusive session, any pending unconfirmed
commits will not be canceled until their timeout periods
expire. A new edit exclusive session cannot be opened
until the timeout period ends.
Deletes all configuration changes.
Immediately commits the current set of configuration changes. This
command will prompt the user to confirm the action. Use the no-
confirm parameter to revert the configuration without requiring
confirmation.
In an edit exclusive session, this command aborts/cancels all
confirmed commits.
Commits all confirmed and unconfirmed changes and exits the
configuration mode.
Validates the current configuration.
Temporarily commits changes for a period of time, allowing users
to test the configuration before fully committing the changes. The
changes must be committed using a standard commit command
before the timeout period ends. If changes are not committed before
the timeout period ends, they are automatically discarded and the
previous settings are restored.
A timeout period can be specified at the end of the command. The
default timeout period is 10 minutes. The minimum timeout period is
1 minute. For example:
ruggedcom(config-admin)# commit confirmed 2
To cancel a commit before the time elapses and discard the
changes, type:
commit abort
To permanently commit the changes before the time elapses, type:
commit
Immediately commits the current set of configuration changes
along with a custom comment. The comment will appear next to the
commit in a list of pending of commits.
Immediately commits the current set of configuration changes
along with a custom label. In a list of pending commits, the label will
appear instead of the auto-generated commit ID.
Immediately commits the current set of configuration changes and
assigns a user-specified ID or flag.
Immediately commits the current set of configuration changes and
saves them to the specified file. It does not save the complete
running configuration.
Chapter 2
Using RUGGEDCOM ROX II
39