Ip Domain Used Server - Siemens SIMATIC NET Configuration Manual

Network protocols
7.1 IPv4 protocol
7.1.2.13

ip domain used server

Description
This command specifies which DNS server the device uses.
Note
Only resource records of type A (IPv4 address of a host) are supported.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
ip domain used server {learned-only | manually-only | all}
The parameters have the following meaning:
Parameter
learned-only
manually-only
all
Result
The device uses the DNS servers specified in the configuration.
294
Description
The device uses only the DNS servers
assigned by DHCP.
The device uses only the manually con-
figured DNS servers. A maximum of
three DNS servers can be configured.
The device uses all available DNS serv-
ers.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Range of values / note
-
-
-
Configuration Manual, 10/2015, C79000-G8976-C351-05