Show Spanning-Tree Mst Configuration - Siemens SIMATIC NET Configuration Manual

Network structures
6.3 Spanning Tree
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameter assignment:
show spanning-tree l2t-edge
Result
The status of the layer 2 tunnel ports is displayed.
6.3.1.7

show spanning-tree mst configuration

Description
This command shows various settings for an instance of the Multiple Spanning Tree
Protocol.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameters:
show spanning-tree mst configuration
Result
The settings of an instance of the Multiple Spanning Tree protocol are displayed.
Further notes
You display the general settings for the Spanning Tree Protocol with the
command.
246
or
cli#
or
cli#
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
show spanning-tree