Commands In The Global Configuration Mode; Mac-Address-Table Aging - Siemens SIMATIC NET Configuration Manual

Syntax
Call up the command with the following parameters:
show vlan port config[{port<interface-type><interface-id>}]
The parameters have the following meaning:
Parameter
port
interface-type
interface-id
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
If you do not select any parameter from the parameter list, the entries of all available
interfaces are displayed.
Result
The information about the ports is displayed.
6.2.2

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
6.2.2.1

mac-address-table aging

Description
With this command, you enable the "Aging" function. The "Aging" function ensures that an
entry in the MAC address list that was learned dynamically is deleted again after a certain
time.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
Description
Keyword for a port
Type of interface
Module no. and port no. of the interface
configure terminal
Range of values / note
-
Enter a valid interface.
command to change to this mode.
or command and are then in the
end exit
Network structures
6.2 VLAN
223