Wlan Signal-Recorder Display (Client) - Siemens SIMATIC NET Configuration Manual

Syntax
● The WLAN interface is enabled.
Call up the command with the following parameters:
wlan signal-recorder <wlan 0/X> stop
The parameter has the following meaning:
Parameter
wlan 0/X
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
Result
The recording was stopped.
Further notes
You start the recording with the
4.2.4

wlan signal-recorder display (client)

Description
With this command, you configure and start recording with the signal recorder without
specifying a total for the measured values. The measured values are output in the CLI and
logged in files. The files can be downloaded as a zip file using http or tftp. The values are
stored every 10 minutes and overwrite the existing values. The file therefore contains the
values the last time they were stored.
Note
This command is only available in the client mode.
Requirement
● The WLAN interface is enabled.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
Description
WLAN interface
or
cli#
wlan signal-recorder start
Functions specific to SCALANCE
4.2 Signal recorder
Range of values / note
Enter a valid interface.
command.
97