Wlan Allowed Channels Only - Siemens SIMATIC NET Configuration Manual

Further notes
You display the list of valid channels with the
command.
The "Allowed channels only" function is activated by the "
command.
See also
wlan allowed channels only (Page 157)
6.1.5.2

wlan allowed channels only

Description
With this command, you enable the "
you specified with the
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call the command without parameter assignment:
wlan allowed channels only
Result
The function is enabled.
Further notes
You display the setting with the
You disable the function with the
See also
wlan allowed channels (Page 155)
no wlan allowed channels only (Page 158)
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
Use allowed channels only
wlan allowed channels list
show wlan allowed channels <wlan 0/X>
no wlan allowed channels only
show wlan allowed channels <wlan 0/X>
wlan allowed channels only
" function. Only the channels
command are used.
command.
Network structures
6.1 WLAN
"
command.
157