No Instance - Siemens SIMATIC NET Configuration Manual

6.3.5.2

no instance

Description
With this command, you cancel the assignment of a VLAN to an MST instance or delete the
MST instance.
Requirement
You are in the MSTP Configuration mode.
The command prompt is as follows:
cli(config-mst)#
Syntax
Call up the command with the following parameters:
no instance <instance-id (1-64)> [vlan <vlan-range>]
The parameters have the following meaning:
Parameter
instance-id
vlan
vlan-range
If you specify a VLAN or a VLAN range, the assignment to an MST instance is canceled.
If you do not specify a VLAN, the MST instance is deleted.
Result
The assignment of a VLAN to an MST instance is canceled or the MST instance is deleted.
Further notes
You assign a VLAN to an MST instance with the
You display this setting and other information with the
configuration
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
Description
Number of the MST instance
Keyword for a VLAN connection
Range of VLANs that will be deleted
from the instance
command.
Range of values / note
1 ... 64
-
enter the range limts with a hy-
phen or blank
command.
instance
show spanning-tree mst
Network structures
6.3 Spanning Tree
277