Vap Security Encryption (Access Point) - Siemens SIMATIC NET Configuration Manual

10.2.5.4

vap security encryption (access point)

Description
With this command, you enable encryption with a fixed (unchanging) WEP key. You can only
enable or disable encryption if you have selected "Open System" for authentication. All other
security methods include both authentication and encryption. If you use "Open system" with
"Encryption" or "Shared Key", you always need to specify the WEP key used for the
encryption.
Note
This command is available only in access point mode.
Requirement
● The type of authentication is "
You are in the Interface Configuration mode of the VAP interface.
The command prompt is as follows:
cli (config-if-vapX-0-Y)#
Syntax
Call the command without parameter assignment:
vap security encryption
Result
The encryption is enabled. You can only disable encryption if you have selected "
for authentication
Further notes
You display the settings with the
You disable the encryption with the
You define a WEP key with the
With the
used for encryption.
See also
no vap security encryption (access point) (Page 422)
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
wlan security edit key
vap security default-key (Access Point)
".
open-system
show wlan security <vapX 0/Y>
no vap security encryption
command, you configure the WEP key
Security and authentication
command.
command.
command.
10.2 WLAN
"
open-sytem
421