Wlan Beacon Interval (Access Point) - Siemens SIMATIC NET Configuration Manual

Network structures
6.1 WLAN
6.1.5.21

wlan beacon interval (access point)

Description
With this command, you specify the interval at which the SCALANCE W700 device sends
beacons. Beacons are packets that are sent cyclically by an access point to inform clients of
its existence.
Note
This command is available only in access point mode.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call up the command with the following parameters:
wlan beacon interval <ms(40-1000)>
The parameter has the following meaning:
Parameters
ms
Result
The interval is specified.
Further notes
You show the set interval with the
174
Description
Length of the interval in milliseconds
(ms).
show wlan advanced <wlan 0/X>
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Range of values / note
40 ... 1000
Default: 100
command.
Configuration Manual, 10/2015, C79000-G8976-C351-05