No Cli-Console-Timeout; Pnio - Siemens SIMATIC NET Configuration Manual

Configuration
3.1 System
3.1.9.8

no cli-console-timeout

Description
With this command, you disable the automatic logout.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no cli-console-timeout
Result
Automatic logout is disabled.
Further notes
You enable automatic logout with the
You display the current timeout setting with the
3.1.9.9

pnio

Description
With this command, you configure the setting for PNIO after the next restart of the device.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
pnio {off|on}
56
command.
cli-console-timeout
show cli-console-timeout
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
command.