Siemens SIMATIC NET Configuration Manual page 83

The parameters have the following meaning:
Parameter
syslog
dhcp
qos
stp
vlan
vlan-id
interface
interface-type
interface-id
ssh
ssl
acl
ip
snmp
radius
sntp
http
locked-port
auto-logout
time
ntp
auto-save
wlan
all
For information on identifiers of interfaces and addresses, refer to the section "Interface
identifiers and addresses (Page 25)".
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
Description
Shows the configuration settings of the Syslog
function
shows the configuration settings of the Dynamic
Host Configuration Protocol
shows the configuration settings of QoS (Quali-
ty of Service)
shows the configuration settings of the Span-
ning Tree Protocol
Keyword for a VLAN connection
Number of the addressed VLAN
Shows that an interface description follows
Type or speed of the interface
Module no. and port no. of the interface
Shows the configuration settings of the Secure
Shell protocol
Shows the configuration settings of the Secure
Sockets Layer protocol
Shows the configuration settings of the access
control list
Shows the configuration settings of the Internet
Protocol
Shows the configuration settings of the Simple
Network Management Protocol
Shows the configuration settings of the Remote
Authentication Dial-In User service
Shows the configuration settings of the Simple
Network Time Protocol
Shows the configuration settings of the Hyper-
text Transfer Protocol
Shows the configuration settings of the locked
port function.
Shows the configuration settings of the auto
logout function
Shows the configuration settings of the system
time
Shows the configuration settings of the Network
Time Protocol
Shows the configuration settings of the auto
save function
Shows the configuration settings of the WLAN
Shows all configuration settings
Configuration
3.4 Configuration Save & Restore
Range of values / note
-
-
-
-
-
1 ... 4094
-
Enter a valid interface.
-
-
-
-
-
-
-
-
-
-
-
-
-
-
83