Commands In The Wds Interface Configuration Mode; Wds Partner Id-Type (Access Point) - Siemens SIMATIC NET Configuration Manual

6.1.7

Commands in the WDS Interface Configuration mode

This section describes commands that you can call up in the WDS Interface Configuration
mode. Depending on the Interface selected, various command sets are available.
In the Global Configuration mode, enter the
mode.
● If you exit the WDS Interface Configuration mode with the
the Global Configuration mode.
● If you exit the WDS Interface Configuration mode with the
Privileged EXEC mode.
6.1.7.1

wds partner id-type (access point)

Description
With this command, you specify whether the WDS partner is detected by the access point by
the MAC address or the WDS ID.
Note
This command is available only in access point mode.
Requirement
You are in the Interface Configuration mode for the WDS interface.
The command prompt is as follows:
cli (config-if-wdsX-0-Y)#
Syntax
Call up the command with the following parameters:
wds partner id-type { mac-address | wds-id }
The parameters have the following meaning:
Parameters
mac-address
wds-id
Result
The type of communication is specified.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
Description
The MAC address is used for communication. With the "
command, you specify the MAC address.
The WDS ID is used for communication. With the "
mand, you specify the WDS ID.
command to change to this
interface wdsX 0/Y
command, you return to
exit
command, you return to the
end
wds partner wds id
Network structures
6.1 WLAN
"
wds partner mac
" com-
213