Wlan Security Context (Client) - Siemens SIMATIC NET Configuration Manual

10.2.2.11

wlan security context (Client)

Description
With this command, you create a new security context and change to the security context
configuration mode.
Note
This command is only available in the client mode.
Requirement
You are in the WLAN configuration mode.
The command prompt is as follows:
cli (config-wlan)#
Syntax
Call up the command with the following parameters:
wlan security context <ID (1-8)>
The parameter has the following meaning:
Parameters
ID
Result
The security context is created,
You are in the security context configuration mode.
The command prompt is as follows:
cli (config-wlan-context-$)#
Further notes
You exit the security context configuration mode with the command
You delete a security context with the
You display the setting with the
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
Description
ID of the security context
no wlan security context
show wlan security
Security and authentication
Range of values / note
1...8
or
end exit
command.
command.
10.2 WLAN
.
401