Show Wlan Security Keys - Siemens SIMATIC NET Configuration Manual

Security and authentication
10.2 WLAN
Result
The settings are displayed.
See also
wlan security ap-radius-authenticator (Page 391)
wlan security ap-radius-authenticator address (Page 393)
wlan security ap-radius-authenticator max-retransmit (Page 394)
wlan security ap-radius-authenticator port-number (Page 395)
wlan security ap-radius-authenticator primary (Page 396)
no wlan security ap-radius-authenticator primary (Page 397)
wlan security ap-radius-authenticator reauth-interval (Page 398)
wlan security ap-radius-authenticator reauth-mode (Page 399)
wlan security ap-radius-authenticator shared-secret (Page 400)
10.2.1.3

show wlan security keys

Description
This command shows a table with the WEP key of the SCALANCE W700 device.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show wlan security-keys < wlan 0/X >
The parameters have the following meaning:
Parameter
wlan 0/X
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
Result
The key table is displayed.
390
or
cli#
Description
WLAN interface
Range of values / note
Enter a valid interface.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05