Commands In The Wlan Configuration Mode; Wlan Security Ap-Radius-Authenticator - Siemens SIMATIC NET Configuration Manual

10.2.2

Commands in the WLAN configuration mode

This section describes commands that you can call up in the WLAN configuration mode.
In the Global Configuration mode, enter the
Commands relating to other topics that can be called in the WLAN configuration mode can
be found in the relevant sections.
● If you exit the WLAN configuration mode with the
configuration mode.
● If you exit the WLAN Configuration mode with the
Privileged EXEC mode.
10.2.2.1

wlan security ap-radius-authenticator

Description
With this command, you enable the RADIUS server.
Note
This command is available only in access point mode.
Requirement
You are in the WLAN Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-wlan)#
Syntax
Call up the command with the following parameters:
wlan security ap-radius-authenticator <index (1-2)>
The parameter has the following meaning:
Parameters
index
Result
The RADIUS server is enabled.
Further notes
You disable the RADIUS server with the
command.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
wlan
Description
Index of the RADIUS server
no wlan security ap-radius-authenticator
Security and authentication
command to change to this mode.
command, you return to the Global
exit
command, you return to the
end
Range of values / note
1...2
10.2 WLAN
391