Wlan Antenna Cable-Length - Siemens SIMATIC NET Configuration Manual

Network structures
6.1 WLAN
cli (config-if-wlan-0-X)#
Syntax
Call up the command with the following parameters:
wlan antenna additional-attenuation <index (1-X)> <dB(0-70)>
The parameters have the following meaning:
Parameter
index
dB
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)"
Result
The additional attenuation is specified.
Further notes
You show the set value with the
6.1.5.13

wlan antenna cable-length

Description
With this command, you configure the cable length between the SCALANCE W700 device
and the external antenna.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call up the command with the following parameters:
wlan antenna cable-length <index(1)> <meter(0-30)>
166
Description
Antenna connector
Attenuation in decibels [dB]
show wlan antennas <wlan 0/X>
Range of values / note
X = 1
0...70
Default: 0
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
command.