Siemens SIMATIC NET Configuration Manual page 26

Description
2.5 Interface identifiers and addresses
Available physical interfaces
Device
W761-1 RJ-45
W722-1 RJ-45
Available logical interfaces
● VLAN
The device supports up to 8 virtual networks.
To be able to use a VLAN, create it with the
● VAP / WDS
The WLAN interface supports 1 virtual access point (VAP) and 1 WDS interface
Identification of the interfaces in the command prompt of the Interface Configuration mode
To configure the interface use the command
Since you configure precisely one of the existing interfaces in the Interface Configuration
mode, the command prompt shows not only the mode but also the identifier of this interface.
The command prompt is as follows:
cli(config-if-$$$)#
The placeholder
Type of interface
wlan 0/X
vapX 0/Y
wdsX 0/Y
fa 0/X
vlan$
The placeholders
26
Interfaces
1 x Fast Ethernet
1 x WLAN
Device interface-type
W722-1 RJ-45
vap
W761-1 RJ-45
vap
wds
is replaced by the following name of the interface:
$$$
X, Y, $
interface-type
fa: fast-ethernet
wlan
vlan
interface-id
X = 1
Y = 1
X = 1
Y = 1
X = 1
Y = 1
interface
Command prompt
cli(config-if-wlan-0-X)#
cli(config-if-vapX-0-Y)#
cli(config-if-wdsX-0-Y)#
cli(config-if-F-0-X)#
cli(config-if-vlan-$)#
stand for the numbering of the interface.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
interface-id
X = 1
X = 1
command.
vapX 0/Y
vapX 0/Y
wdsX 0/Y
in the global configuration mode.
fa 0/X
wlan 0/X