You show the NAT configuration and the translation list with the
show nat (Client) (Page 371)
nat interface (Client)
This command is only available in the client mode.
With this command, you enable NAT for the Ethernet interface.
You are now in the NAT Configuration mode.
The command prompt is as follows:
● "Own" is set for "MAC Mode".
Call up the command with the following parameters:
nat interface <interface-type><interface-id>}
The parameters have the following meaning:
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
NAT is activated for the Ethernet interface.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
Type or speed of the interface
Module no. and port no. of the interface
Layer 3 functions
Range of values / note
Enter a valid interface.