Wlan Force Roaming Eth-Down (Access Point) - Siemens SIMATIC NET Configuration Manual

Network structures
6.1 WLAN
The parameters have the following meaning:
Parameters
index
enable
disable
delete
ssid
Result
The corresponding index entry in the SSID list is changed or deleted.
Further notes
You display the list with the
You delete an SSID entry with the
6.1.5.41

wlan force roaming eth-down (access point)

Description
If the wired Ethernet interface is no longer available (cable break, connector removed), a
client connected over the wireless network is not aware of this.
The access point can force the logged-on clients to roam by deactivating its WLAN interface.
The client then attempts to log on at a different access point. With this command, you enable
this function.
Note
This command is available only in access point mode.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
192
Description
Index entry in the SSID list
Entry is used
Entry is not used
Entry is deleted. The
ssid
rameter is ignored.
SSID
show wlan ssid-table <wlan 0/X>
wlan ssid-table edit <index (1-8)> delete
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Range of values / note
1...8
--
Default
pa- --
Enter the SSID of the access point.
The length of the character string for SSID
is 1 to 32 characters. ASCII code 0x20 to
0x7e is used for the SSID.
To be able to use spaces in the SSID, enter
the SSID in quotes:
wlan ssid-table edit "H a l l o"
command.
Configuration Manual, 10/2015, C79000-G8976-C351-05
command.