The "Show" Commands - Siemens SIMATIC NET Configuration Manual

File type
WLANAuthlog
WLANCert
(in client mode only)
WLANServerCert
(in client mode only)
WLANSigRec
(in client mode only)
WLANSpectru-
mAnalyzer
(Only in access
point mode)
3.2.1

The "show" commands

This section describes commands with which you display various settings.
With the command
configuration mode.
To do this, you replace
Example
do show cli-console-timeout
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
Description
File with entries from the WLAN Authentication Log
(information on successful or failed authentication
attempts)
User certificate. You can specify a password for the
user certificate on the WBM page "Load&Save >
Password".
Server certificate
The zip file contains the following:
csv file with the measured values of the signal
•
recorder
pdf file with the measured values and an addition-
•
al graphic representation of the measured values.
You will find information about the measured values
and their graphic representation in the section "Signal
recorder (Page 94)".
The Zip file contains a csv file with the measured
values of the spectrum analyzer.
You will find information about the measured values
and their graphic representation in the section "Auto-
Hotspot".
you can execute the "show" commands in every
do [command]
with the "show" command that you want to execute.
[command]
Configuration
3.2 Load and Save
Save Down-
load
X --
X X
X X
X --
X --
69