6.2.1.3
show mac-address-table count
Description
With this command, you show the number of MAC addresses for all or a selected VLAN.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show mac-address-table count[vlan<vlan-id(1-4094)>]
The parameters have the following meaning:
Parameter
vlan
vlan-id
If you do not select any parameter from the parameter list, the total number of entries is
displayed for all VLANs.
Result
The number of MAC addresses for the selected VLAN is displayed.
6.2.1.4
show mac-address-table dynamic unicast
Description
This command shows the MAC addresses of the dynamic unicast configuration.
Requirement
● In "base bridge-mode", the mode for the device is set to "transparent".
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
or
cli#
Description
Keyword for a VLAN connection
Number of the addressed VLAN
or
cli#
Network structures
6.2 VLAN
Range of values / note
-
1 ... 4094
219