Clear Counters - Siemens SIMATIC NET Configuration Manual

Configuration
3.1 System
Syntax
Call the command without parameters:
show versions
Result
The following settings are displayed:
● Basic device
● Name
● Revision
● Order ID
● Firmware
● Bootloader
● Description
● Version
● Date
3.1.2

clear counters

Description
With this command, you reset the counters of an interface.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
clear counters [<interface-type><interface-id>]
The parameters have the following meaning:
Parameter
interface-type
interface-id
44
or
cli#
Description
Type or speed of the interface
Module no. and port no. of the interface
Range of values / note
Specify a valid interface.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05