10.2.4.6
wlan security dot1x eap-authentication-type (client)
Description
With this command, you specify which RADIUS authentication methods the client offers to
the RADIUS server. With "
Any other selection restricts the support by the client to this one method.
Note
This command is only available in the client mode.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-wlan-context-x)#
Syntax
Call up the command with the following parameters:
wlan security dot1x eap-authentication-type { show-types | <type> }
The parameters have the following meaning:
Parameters
show-types
type
Result
The authentication method is specified.
Further notes
You display the settings with the
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
", the client offers a RADIUS server all supported methods.
auto
Description
Lists the available authenti-
cation methods
Value that contains the au-
thentication method
show wlan security
Security and authentication
Range of values / note
•
auto
Client offers RADIUS server all methods
•
eap-tls
Extensible Authentication Protocol - Transport
Layer Security: Uses certificates for authentica-
tion
•
eap-ttls
Extensible Authentication Protocol - Tunnel
Transport Layer Security: After setting up the
TLS tunnel, MS-CHAPv2 is used for internal au-
thentication.
•
peap
Protected Extensible Authentication Protocol: Al-
ternative draft protocol of IETF for EAP-TTLS
command.
10.2 WLAN
411