Wlan Background Scan Interval (Client) - Siemens SIMATIC NET Configuration Manual

Network structures
6.1 WLAN
6.1.5.19

wlan background scan interval (client)

Description
With this command, you specify the Interval at which the client scans for further access
points.
Note
This command is only available in the client mode.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call up the command with the following parameters:
wlan background scan interval <ms(300-60000)>
The parameter has the following meaning:
Parameters
ms
Result
The interval is specified.
Further notes
You show the set interval with the
172
Description
Time in milliseconds (ms) 300 ... 60 000
show wlan client <wlan 0/X>
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
Range of values / note
Default: 5000
command.