Show Snmp Engineid; Show Snmp Filter - Siemens SIMATIC NET Configuration Manual

Network protocols
7.4 SNMP
7.4.1.3

show snmp engineID

Description
This command shows the SNMP identification number of the device.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameters:
show snmp engineID
Result
The SNMP identification number of the device is displayed.
7.4.1.4

show snmp filter

Description
This command shows the configured SNMP filters.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameters:
show snmp filter
Result
The configured SNMP filters are displayed.
326
or
cli#
or
cli#
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05