No Nat Interface (Client) - Siemens SIMATIC NET Configuration Manual

Layer 3 functions
9.1 NAT
Further notes
You disable NAT with the
You configure the MAC mode with the
You show the NAT configuration and the translation list with the
See also
show nat (Client) (Page 371)
9.1.3.5

no nat interface (Client)

Note
This command is only available in the client mode.
Description
With this command, you disable NAT.
Requirement
You are now in the NAT Configuration mode.
The command prompt is as follows:
cli(config-nat)#
Syntax
Call the command without parameters:
no nat interface
Result
NAT is disabled.
Further notes
You enable NAT with the
See also
show nat (Client) (Page 371)
378
command.
no nat interface
wlan client mac mode
command.
nat interface
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
command.
command.
show nat