Siemens SIMATIC NET Configuration Manual page 364

Network protocols
7.8 ARP
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show ip arp [{Vlan<vlan-id(1-4094)>|<interface-type><interface-id>|
The parameters have the following meaning:
Parameter
Vlan
vlan-id
interface-type
interface-id
ip-address
mac-address
summary
information
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
If you do not select any parameter from the parameter list, the IP ARP table is displayed.
Result
The IP ARP table is displayed.
364
or
cli#
<ip-address>|<mac-address>|summary|information}]
Description
Keyword for a VLAN connection
Number of the addressed VLAN
Type or speed of the interface
Module no. and port no. of the interface
Shows the IP addresses of the entries
in the ARP table
Shows the MAC addresses of the en-
tries in the ARP table
Shows a summary of the entries in the
ARP table
Displays information on the ARP con-
figuration
Range of values / note
-
1 ... 4094
Enter a valid interface.
-
-
-
-
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05