Ip Dhcp-Server Icmp-Probe - Siemens SIMATIC NET Configuration Manual

Network protocols
7.3 DHCP server
7.3.2.3

ip dhcp-server icmp-probe

Note
The command is only available with the following device:
• SCALANCE W722-1 RJ-45 (MLFB 6GK5722-1FC00-0AA0 and 6GK5722-1FC00-0AB0
(US version))
• SCALANCE W761-1 RJ45 in access point mode (article number): 6GK5761-1FC00-0AA0
and 6GK5761-1FC00-0AB0 (US version))
Description
With this command, you enable the "Probe address with ICMP Echo before offer" function.
The DHCP server checks whether or not the IPv4 address has already been assigned. If no
reply is received, the DHCP server can assign the IPv4 address.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
ip dhcp-server icmp-probe
Result
The function is enabled.
Further notes
You disable the function with the
308
no ip dhcp-server icmp-probe
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
command.