Configure Terminal - Siemens SIMATIC NET Configuration Manual

For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
If no parameters are specified, the counters for all interfaces are reset.
Result
The counters of the interface are reset.
Further notes
You can display the statistical information of the interfaces with the
counters
3.1.3

configure terminal

Description
With this command, you change to the Global configuration mode.
Requirement
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Syntax
Call the command without parameters:
configure terminal
Result
You are now in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Further notes
You exit the Global configuration mode with the
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
command.
show interfaces -
command.
end
Configuration
3.1 System
45