Commands In The Global Configuration Mode; User-Account - Siemens SIMATIC NET Configuration Manual

Security and authentication
10.1 User rights management
Syntax
Call the command without parameters:
show users
Result
The logged in users are displayed.
10.1.4

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
10.1.4.1

user-account

Description
With this command, you specify a new user. You can also change the password / role of an
already created user.
Note
You can create up to 16 additional users.
Requirement
● The user is logged in with the "admin" role.
● You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
384
command to change to this mode.
configure terminal
or
end exit
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
command and are then in the