Commands In The Wlan Interface Configuration Mode; Wlan Allowed Channels - Siemens SIMATIC NET Configuration Manual

Syntax
Call up the command with the following parameters:
country { show-countries | code <iso code> }
The parameters have the following meaning:
Parameters
show-countries
iso code
Result
The country is specified for the SCALANCE W700 device.
Further notes
You display the setting with the
See also
show wlan device (Page 141)
6.1.5

Commands in the WLAN Interface configuration mode

This section describes commands that you can call up in the WLAN Interface Configuration
mode. Depending on the Interface selected, various command sets are available.
In the Global Configuration mode, enter the
mode.
● If you exit the WLAN Interface Configuration mode with the
the Global Configuration mode.
● If you exit the WLAN Interface Configuration mode with the
the Privileged EXEC mode.
6.1.5.1

wlan allowed channels

Description
This command specifies which of the permitted channels the SCALANCE W700 device can
use. A list of the permitted channels is created.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
Description
Shows a list of the countries that can be
set along with their two-digit ISO codes.
Country code The country code com-
plies with ISO 3166.
show wlan device
interface wlan 0/X
Range of values / note
--
Enter the ISO code of the re-
quired country.
command.
command to change to this
command, you return to
exit
command, you return to
end
Network structures
6.1 WLAN
155