vap broadcast ssid (access point)
With this command, you enable the "Broadcast SSID" function. The SSID is sent in the
frame of the access point and is visible for other SCALANCE W700 devices. This means that
clients on which the "Any SSID" option is enabled can also connect to the access point.
This command is available only in access point mode.
You are in the Interface Configuration mode of the VAP interface.
The command prompt is as follows:
Call the command without parameter assignment:
vap broadcast ssid
The function is enabled.
You display the setting with the
You disable the function with the
no vap broadcast ssid (access point) (Page 210)
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
show wlan vap <vap X 0/Y>
no vap broadcast ssid