No Switchport Priority Default - Siemens SIMATIC NET Configuration Manual

Syntax
Call up the command with the following parameters:
switchport priority default <0-7>
The parameter has the following meaning:
Parameter
-
Result
The setting for the default priority of the interface is configured.
Further notes
You reset the priority default to the original default with the
command.
You display this setting and other information with the
6.2.3.7

no switchport priority default

Description
With this command, you reset the priority default for the interface to the default value.
The default value is 0.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no switchport priority default
Result
The setting is reset to the default value.
Further notes
You configure the priority default with the
You display this setting and other information with the
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
Description
Value for the priority default
switchport priority default
Network structures
Range of values / note
0 ... 7
Default: 0
no switchport priority default
show vlan port config
command.
show vlan port config
6.2 VLAN
command.
command.
233