Wlan Ssid-Table Edit (Client) - Siemens SIMATIC NET Configuration Manual

Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call up the command with the following parameters:
wlan dtim <1-15>
The parameter has the following meaning:
Parameters
1-15
Result
The DTIM interval is configured.
Further notes
You display the setting with the
6.1.5.40

wlan ssid-table edit (client)

Description
With this command, you change or delete an entry in the SSID list.
Note
This command is only available in the client mode.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call up the command with the following parameters:
wlan ssid-table edit <index (1-8)> {enable | disable| delete} [ssid]
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
Description
DTIM interval after which the collected pack-
ets are sent to the client.
show wlan advanced <wlan 0/X>
Network structures
6.1 WLAN
Range of values / note
1...15
Default: 1
command.
191