Commands In The Global Configuration Mode; Wlan - Siemens SIMATIC NET Configuration Manual

6.1.3

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
6.1.3.1

wlan

Description
With this command, you change to the WLAN Configuration mode.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
wlan
Result
You are in the WLAN Configuration mode.
The command prompt is as follows:
cli (config-wlan)
Further notes
You exit the particular WLAN Configuration mode with the
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
configure terminal
#
command to change to this mode.
or command and are then in the
end exit
or command.
end exit
Network structures
6.1 WLAN
151