Show Ip Route - Siemens SIMATIC NET Configuration Manual

7.1.1.3

show ip route

Description
This command shows the routes currently being used.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show ip route[{<ip-address>[<mask>]|connected|static}]
The parameters have the following meaning:
Parameter
ip-address
mask
connected
static
Result
The routing table is displayed.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
or
cli#
Description
shows the information for a specific IP address
defines an address range using the subnet mask
Shows the direct connections
Shows the static connections
Network protocols
7.1 IPv4 protocol
Range of values /
note
enter a valid IP ad-
dress
/8, /16 or /24
-
-
283