Commands In The Nat Configuration Mode; Nat (Client) - Siemens SIMATIC NET Configuration Manual

Syntax
Call the command without parameters:
nat
Result
You are now in the NAT Configuration mode.
The command prompt is as follows:
cli(config-nat)#
Further notes
You exit the NAT Configuration mode with the
9.1.3

Commands in the NAT configuration mode

This section describes commands that you can call up in the NAT Configuration mode.
In the Global Configuration mode, enter the
● If you exit the NAT Configuration mode with the
Configuration mode.
● If you exit the NAT Configuration mode with the
Privileged EXEC mode.
9.1.3.1

nat (Client)

Note
This command is only available in the client mode.
Description
With this command, you configure the translation list for communication from the global to
the local network.
A maximum of 60 entries are possible.
Requirement
You are now in the NAT Configuration mode.
The command prompt is as follows:
cli(config-nat)#
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
or command.
end exit
command to change to this mode.
nat
command, you return to the Global
exit
command, you return to the
end
Layer 3 functions
9.1 NAT
373