Snmp Notify - Siemens SIMATIC NET Configuration Manual

Syntax
Call up the command with the following parameters:
no snmp group <GroupName> user <UserName>security-model{v1|v2c|v3}
The parameters have the following meaning:
Parameter
GroupName
user
UserName
security-model
Result
The details of the group are deleted.
Further notes
You change the details of an SNMP group with the
You display the created SNMP groups with the
You display the created SNMP user with the
7.4.2.12

snmp notify

Description
With this command, you configure the details of the SNMP notifications.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
Description
Name of the group
Keyword for the user name
Name of the user
Specifies which security settings are
used for sending
show snmp user
Range of values / note
max. 32 characters
-
max. 32 characters
•
v1
•
v2c
•
v3
command.
snmp group
command.
show snmp group
command.
Network protocols
7.4 SNMP
341