No Vap Wds Only (Access Point) - Siemens SIMATIC NET Configuration Manual

Network structures
6.1 WLAN
6.1.6.6

no vap wds only (access point)

Description
With this command, you specify that the access point supports not only communication via
WDS. This setting is activated as default.
Note
This command is available only in access point mode.
Requirement
You are in the Interface Configuration mode of the VAP interface.
The command prompt is as follows:
cli (config-if-vapX-0-Y)#
Syntax
Call the command without parameter assignment:
no vap wds only
Result
You have specified who the VAP interface connects to.
Further notes
You display the setting with the
You enable the function with the
See also
vap wds only (access point) (Page 211)
212
show wlan vap <vap X 0/Y>
command.
vap wds only
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
command.