Wds Partner Mac (Access Point) - Siemens SIMATIC NET Configuration Manual

Network structures
6.1 WLAN
Further notes
You display the setting with the
See also
wds partner mac (access point) (Page 214)
wds partner wds-id (access point) (Page 215)
6.1.7.2

wds partner mac (access point)

Description
With this command, you enter the MAC address of the WDS partner.
Note
This command is available only in access point mode.
Requirement
You are in the Interface Configuration mode for the WDS interface.
The command prompt is as follows:
cli (config-if-wdsX-0-Y)#
Syntax
Call up the command with the following parameters:
wds partner mac <mac-address>
The parameter has the following meaning:
Parameters
mac-address
Result
The MAC address is specified.
Further notes
You display the setting with the
See also
wds partner id-type (access point) (Page 213)
214
show wlan wds <wdsX 0/Y>
Description
MAC address of the communications partner
show wlan wds <wdsX 0/Y>
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
command.
command.