show wlan wds-list (access point)
This command shows the WDS partners connected to the WLAN interface.
This command is available only in access point mode.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
Call up the command with the following parameters:
show wlan wds-list <wlan 0/X>
The parameter has the following meaning:
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
The WDS partners of the WLAN interface are displayed.
show wlan ip-mapping
This command shows the table for the IP mapping. The table contains the assignment of
MAC address and IP address of the SCALANCE W700 devices for which the client makes
WLAN access possible.
This page is only available for clients or access points in client mode.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
Range of values / note
Enter a valid interface.