Nat Local Ip Address (Client) - Siemens SIMATIC NET Configuration Manual

Layer 3 functions
9.1 NAT
Further notes
You show the NAT configuration and the translation list with the
You configure entries with the
See also
show nat (Client) (Page 371)
9.1.3.3

nat local ip address (Client)

Note
This command is only available in the client mode.
Description
With this command, you configure the IP address of the Ethernet interface. This IP address
is the gateway address of the local device.
Requirement
You are now in the NAT Configuration mode.
The command prompt is as follows:
cli(config-nat)#
Syntax
Call up the command with the following parameters:
nat local ip address <ip-address> {<subnet-mask>|/<prefix-length(0-32)>
The parameters have the following meaning:
Parameters
ip-address
subnet-mask
prefix-
length
Result
The local IP address of the Ethernet interface is configured.
376
command.
nat
Description
Address of the Ethernet interface
Subnet mask of the local Ethernet
Decimal representation of the mask as
a number of "1" bits
Range of values / note
enter a valid IP address
enter a valid subnet mask
1 ... 32
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
command.
show nat