No Nat Timeout (Client) - Siemens SIMATIC NET Configuration Manual

Layer 3 functions
9.1 NAT
9.1.3.7

no nat timeout (Client)

Note
This command is only available in the client mode.
Description
With this command, you delete the time period for the TCP / UDP connection.
Requirement
You are now in the NAT Configuration mode.
The command prompt is as follows:
cli(config-nat)#
Syntax
Call up the command with the following parameters:
no nat {tcp|udp} timeout
The parameters have the following meaning:
Parameters
tcp
udp
Result
The time period for the TCP / UDP connection was set to the default setting.
Further notes
You show the NAT configuration and the translation list with the
You configure the time with the
See also
show nat (Client) (Page 371)
380
Description
TCP connection
UDP connection
command.
nat timeout
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
Range of values / note
-
-
command.
show nat